TextEditor

This is a simple command-line text editor.

Usage

In order to use the text editor complete the following steps.

1. Clone the repository and change to the project directory:

git clone https://github.com/rakhmukova/TextEditor/
cd TextEditor

2. Compile the program using 'make' and run it with './editor':

make
./editor

Use the commands listed below to modify text. Type 'h' to see the list of commands and 'q' to exit.

Commands

Here is the list of available commands:

• a [text]: Add text to the end.
• i [position] [text]: Insert text at a specific position.
• put [text]: Put text under the cursor.
• d [number of symbols]: Delete a specified number of symbols before the cursor.
• c [centre | reach | cross]: Switch the cursor strategy.
• f [text]: Find text.
• rm [start] [end]: Remove symbols from a specified starting position to an ending position.
• rp [text1] [text2]: Replace each occurrence of text1 with text2.
• m [position]: Move the cursor to a specific position.
• lw [number of words]: Move the cursor left by a specified number of words.
• rw [number of words]: Move the cursor right by a specified number of words.
• p [-h [height]] [-w [width]] [-v [volume]]: Change editor parameters, such as height, width, or volume.
• up: Transform the text under the cursor to uppercase.
• low: Transform the text under the cursor to lowercase.
• s [filename]: Save the text to a file.
• l [filename]: Load a text from a file.
• h: Display a help message.
• q: Quit the text editor.