Veno-Echo is a powerful stereo digital delay device for Eurorack synthesizers. This is the first module from Venus Instruments.
ABOUT
• Two separate channels with independent controls for delay time, feedback, and reverse direction. Combine with width and cross feedback, for total control over the stereo soundscape
• Warm wet line high-pass and low-pass filters, with configurable cut-off frequencies and resonance, tailor the character of your repeats
• Artefact-free transitions for all parameter changes. Mash the time controls for stuttering glitch and shuffle effects, or send wild CV modulation to multiple parameters, all without clicks or pops
• Modulation CV input to sculpt your own pitch wobble
• Tap in the tempo or use the clock input, and select a multiplier or divider for each channel, to generate rhythmic patterns which stay in sync with the rest of your system
FEATURES
• Stereo inputs and outputs
• High performance op-amps in the audio path
• Independent delay time, feedback, and reverse controls for each channel
• Tap tempo and externally clockable
• Stereo width and cross feedback controls
• Extensive CV controls, including external modulation input
• Low pass and high pass filters on wet line with adjustable cutoff frequencies and resonance
• Performance oriented filter crossfade control
• Configurable filters to pre or post feedback loop
• Internal modulation with adjustable rate and depth
• Feedback up to 125% to allow for run-away repeats
• Right input normals to the left input for mono to stereo operation
• Gate inputs for reverse switching
• Built around the Electrosmith Daisy embedded platform
SPECIFICATIONS
• Audio quality: 24-bit, 48kHz
• Width: 20hp
• Depth: 32mm
• Current draw: +12V 80mA, -12V 80mA (5V 0mA)
• Delay time range: <5ms to 36s
• CV input range: -5V to +5V
How to flash Firmware:
If you are using Windows you may need to reset the Seed's USB driver before proceeding. Check out the instructions using Zadig here: https://github.com/electro-smith/DaisyWiki/wiki/Using-Zadig-to-Reset-USB-Driver-(Windows-Only)
- Download the latest firmware .bin file from Veno-Echo/Firmware
- Connect the Veno-Echo to your computer via the micro-USB port on the back
- Press both buttons on the back of the module (either side of the micro-USB port)
- Go to https://electro-smith.github.io/Programmer/ using Chrome
- Click Connect, select 'DFU in FS Mode - Paired' and Connect
- Under 'Or select a file from your computer' hit Browse, and point it at the downloaded .bin file
- Hit Program and wait until it completes.