You can use a hex file with inputs for simulation. Enable this with the macro SIM_INPUTS. The file must be called sim_inputs.hex. Each line has a hexadecimal number with inputs coded. Active high only:
| bit | meaning |
|---|---|
| 0 | coin 1 |
| 1 | coin 2 |
| 2 | 1P start |
| 3 | 2P start |
| 4 | right (may vary with each game) |
| 5 | left (may vary with each game) |
| 6 | down (may vary with each game) |
| 7 | up (may vary with each game) |
| 8 | Button 1 |
| 9 | Button 2 |
| 10 | Test button |
Each line will be applied on a new frame.
Starting from the Dec. 2020 firmware update, MiST can now delegate the ROM load to the FPGA. This makes the process 4x faster. This option is enabled by default. However, it can be a problem because the ROM transfer will be composed of full SD card sectors so there will be some garbage sent at the end of the ROM. If the core is not compatible with this and it relies on exact sizing of the ROM it needs to define the macro JTFRAME_MIST_DIRECT and set it to zero:
set_global_assignment -name VERILOG_MACRO "JTFRAME_MIST_DIRECT=0"
In order to preserve the 8-bit ROM download interface with MiST, jtframe_mister presents it too. However it can operate internally with 16-bit packets if the macro JTFRAME_MR_FASTIO is set to 1. This has only been tested with 96MHz clock. Indeed, if JTFRAME_CLK96 is defined and JTFRAME_MR_FASTIO is not, then it will be defined to 1.
The measured speed for data transfers in MiSTer is about 1.2MHz (800ns) per request. If JTFRAME_MR_FASTIO is set, each request is 16-bit words, otherwise, 8 bits.
A model for SDRAM mt48lc16m16a2 is included in JTFRAME. The model will load the contents of the file sdram.hex if available at the beginning of simulation.
The current contents of the SDRAM can be dumped at the beginning of each frame (falling edge of vertical blank) if JTFRAME_SAVESDRAM is defined. Because this is quite an overhead, it is possible to restrict it to dump only a certain DUMP_START frame count has been reached. All frames will be dumped after it. The macro DUMP_START is the same one used for setting the start of signal dump to the VCD file.
To simulate the SDRAM load operation use -load on sim.sh. The normal download speed 1/270ns=3.7MHz. This is faster than the real systems but speeds up simulation. It is possible to slow it down by adding dead clock cycles to each transfer. The macro JTFRAME_SIM_LOAD_EXTRA can be defined with the required number of extra cycles.
Define and export the following environgment variables to have these modules added to your simulation when using sim.sh
YM2203 YM2149 YM2151 MSM5205 M6801 M6809 I8051
Many modules are also added depending on the contents of the project qip file.