Skip to content

Latest commit

 

History

History
23 lines (17 loc) · 618 Bytes

printing.md

File metadata and controls

23 lines (17 loc) · 618 Bytes

Print setting

Slicer config

This is the setting I'm using but any other settings will work as long as the parts are strong enough.

Layer height : 0.2mm
Wall count : 5
Top/bottom layer : 5
Infill : 30% Gyroid 
Outer wall line width : 0.4mm
Inner wall line width : 0.45mm
Infill line width : 0.5mm

Filament

  • In theory, PETG and higher temp-resistant filaments will work.
  • Motor mount and tool head parts might require higher themp-resistant filament.
  • If possible use strong filament for Z axis parts.
  • Gillter or CF filled filaments might make the parts more brittle.

Parts orientation