No data

[Danifly80]

Hi!
I'm trying to integrate Glow in my home assistant but I'm struggling with it.

I assembly all the components and I program the ESP32 without a problem, also I integrate the ESP in home assistant, and I can also open the web server without any problem or delay.

The problem is that I can't give any data, the RGB led doesn't flash when the meter flash but It flash blue on startup before connects to wifi.

I check the diode soldering and also I tried to use another diode, with no luck.
I also recheck and use different rgb led.

do you have any Idea?

Esp32 glow regulary update wifi signal on HA

my Meter use a 1Wh/imp value by as you suggest me before I red this link and I didn't modify de default value of "1000"

web server:

22:31:58	[D]	[button:013]	'Reset - Total Energy' Pressed.
22:32:02	[D]	[button:013]	'Restart - Glow' Pressed.
22:32:02	[I]	[restart.button:012]	Restarting device...
22:32:02	[I]	[app:133]	Rebooting safely...
22:32:02	[D]	[esp32.preferences:114]	Saving preferences to flash...
22:32:47	[D]	[esp32.preferences:114]	Saving preferences to flash...
22:33:53	[D]	[sensor:125]	'House - WiFi Signal': Sending state -68.00000 dBm with 0 decimals of accuracy

thanks for the help

[klaasnicolaas]

Do you get a response when you shine the flashlight over the photodiode? The PCB of the photodiode connected to the correct GPIO pins?

[klaasnicolaas]

Good to know that the photodiode board does indicate that a pulse has been detected. Are you using the correct GPIO port?

[Danifly80]

I thinks so, I've built two different Glow with two different esp32 board from different vendor and two different photodiode but from the same result.

GPIO port are

ESP32 --> Phtd
3V3 --> VCC
G13 --> DO
GND --> GND

[Danifly80]

@klaasnicolaas any other advice?

[klaasnicolaas]

But is GPIO13 also set in the yaml code? What version of the yaml code are you using?

[Danifly80]

Sorry for my late answer, busy week.

Everything was my fault, linked to my very small experience of esp home (for the moment :D )

I've installed the glow using Crome and https://klaasnicolaas.github.io/home-assistant-glow/

so the version installed was the 3.0 but I connection scheme at this address: https://github.com/klaasnicolaas/home-assistant-glow/tree/v3.1.0

Now I've installed the 3.1.0 and everything work well, I had some problems with some extreme random value but it seams solved with internal_filter: 100ms

I will check in the next days if everything is good!

Thanks for the help!