- Screw the LoRa32 module in its frame using 2mm screws.
- Screw the Banana Pi Zero into its frame using 2.5mm screws.
- Screw the Antenna Cable into the top part of the case.
- Put the LoRa32 into the top case, make sure to run the cables as shown in the picture.
- Add the middle part of the case.
- Connect the Banana Pi Zero to the LoRa32 module and place the JST-SM connector in the case as shown in the picture.
- Put the Dupont debug connector in the slot between top and middle case parts (It should be held in place once screws are tightened).
- Place the Banana Pi Zero in the middle case part. Lead the antenna cable through the gap and plug it into the Banana Pi Zero
- Put the bottom case part on top and use 3mm screws to tighten it.
- Attach the antennas.
- One of:
- Attach an serial<->USB adapter to the debug port and connect it via USB with your PC.
- Connect a monitor via the HDMI port.
Continue with Setting up the System