CCS811_test.ino

/***************************************************************************
  This is a library for the CCS811 air

  This sketch reads the sensor

  Designed specifically to work with the Adafruit CCS811 breakout
  ----> http://www.adafruit.com/products/3566

  These sensors use I2C to communicate. The device's I2C address is 0x5A

  Adafruit invests time and resources providing this open source code,
  please support Adafruit andopen-source hardware by purchasing products
  from Adafruit!

  Written by Dean Miller for Adafruit Industries.
  BSD license, all text above must be included in any redistribution

 
  Adapted to CubeCell HTCC-AB01 by Mike Cochrane
  Hardware Connections:
  
   CubeCell Pin  CCS811 Board  Function
   
   Vext          VCC              Power
   GND           GND              Ground
   SDA           SDA              I2C Data
   SCL           SCL              I2C Clock
   GND           WAKE             Wake, active low 
 
 ***************************************************************************/

#include "Adafruit_CCS811.h"

Adafruit_CCS811 ccs;

void setup() {
  Serial.begin(115200);
  pinMode(Vext, OUTPUT);
  digitalWrite(Vext, LOW); //set vext to high
  delay(500);

  Serial.println("CCS811 test");

  if(!ccs.begin()){
    Serial.println("Failed to start sensor! Please check your wiring.");
    while(1);
  }

  // Wait for the sensor to be ready
  while(!ccs.available());
}

void loop() {
  if(ccs.available()){
    if(!ccs.readData()){
      Serial.print("CO2: ");
      Serial.print(ccs.geteCO2());
      Serial.print("ppm, TVOC: ");
      Serial.println(ccs.getTVOC());
    }
    else{
      Serial.println("ERROR!");
      while(1);
    }
  }
  delay(1000);
}