This pin boot cover is made to fit my Flipper Zero WiFi Dev Board case found at the following locations:
This is a remix of AWOK's ESP32 V4 case cover (https://www.thingiverse.com/thing:5961313), which is quite beautiful. I highly recommend their products.
My print settings:
- Hatchbox PLA
- 0.2mm layer height
- 0.4mm nozzle (line width)
- Enable retraction
- Wall count 3 (+ print thin walls enabled)
- Top/bottom layers: 4
- Infill density: 20%
- Infill pattern: Cubic
- Print temp 200 C
- Bed temp 60 C
- No supports needed
Enjoy!
CC-BY-NC-4.0 (view license)
