A quick case I put together to fit the CC1101 expansion board made by TehRabbitt. The board can be purchased on Tindie here. The board is designed to be used with the Flipper Zero, which can be found here.
To assemble the case, you'll need two M2x10mm screws and two M2 nuts.
This design also has a pin protector boot cover that can be found in the following locations:
My print settings:
- Hatchbox PLA
- 0.2mm layer height
- 0.4mm nozzle (line width)
- Enable retraction
- Wall count 3 (+ print thin walls enabled)
- Top/bottom layers: 4
- Infill density: 20%
- Infill pattern: Cubic
- Print temp 200 C
- Bed temp 60 C
- No supports needed
Enjoy!
-
Flipper Zero - CC1101 Board by TehRabbitt - Case (top + bottom): 3mf | stl | view
-
Flipper Zero - CC1101 Board by TehRabbitt - Case (top only): 3mf | stl | view
-
Flipper Zero - CC1101 Board by TehRabbitt - Case (bottom only): 3mf | stl | view
CC-BY-NC-4.0 (view license)
