Stabilization Print quality / look-ahead

[smeyernyc]

Running MRISCOC on an Ender 3 v2 with Cura. Running with no stabilization, everything works perfectly. When stabilizing, almost every layer has stringing. I attempted to enable look-ahead but it says there are no blocks. I am still very new to all this and some guidance would be appreciated.

[cmuche]

Hi @smeyernyc
Stringing is a problem that will always happen in some form when stabilizing. It also heavily depends on your model (like amount of infill, perimeters, ...). Can you maybe provide your GCODE file for which Timelapse+ couldn't find any infill blocks? Which slicer do you use? Or you can check the GCODE file yourself with these information.
I have an Ender 3 V2 with the custom firmware myself (however I installed the Sprite Extruder) and the retraction settings helped reduce stringing for me:

But since you have a different print head, you should match those settings to be closer to your slicer's retraction settings.

[smeyernyc]

https://youtu.be/FVQ8owGhm4A
CE3E3V2_Side Caddy V2 v1.zip
Made in Cura 5.6 printed on Ender 3V2 stock head running MRISCOC (I think UBL, not AML 2.0 at the time)
Thank you!

[smeyernyc]

@cmuche I think I figured it out. My printhead parking was out of limits which I think broke everything else. I also really appreciate your guidance on movement settings. Night and day difference. I must have missed that documentation when setting it up if it was there.